Upgrades now included as standard for 2021 March 17, 2021
UPGRADE #1 Third Cathode Electrode (Stainless Steel Cathode): We will now be providing three electrodes, by adding a second mode of operation (UNIPOLAR) in order to expedite the process of charging the water, while maintaining high quality. The previous traditional BIPOLAR mode is still available by switching the Alternating Polarity switch to the ON (UP) position. In the traditional BIPOLAR (Alternating) mode we had only two electrode plates where the electrical current was alternately switched from one plate to the other, each plate being anode briefly. In Electrolysis, only the anodes release atoms, while the opposite cathode remains neutral. Taste the water to verify ppm. Don’t rely on the conductivity meter which measures only ions, not nanoparticles.
BIPOLAR TRADITIONAL MODE 1: Alternating ON: Remove the Stainless Steel plate. Put the active electrodes in the two red outlets. These two outer silver (or other) active electrodes will be alternately anode and cathode. This mode is better for highest quality of nanoparticles.
UNIPOLAR MODE 2: Alternating OFF Insert the SS plate in the black outlet. Put the active electrodes in the two red outlets. The two outer silver (or other) active electrodes will be Anodes, connected together thereby using the total summated area of both electrodes, thereby doubling productivity. These two anodes are driven by the positive wire attached to the red outlet on the base of your generator. The central stainless steel (or any other metal) electrode will be Cathode, connected by the negative black wire to the central black outlet on the base of your generator. This polarity is important. Thus the two anodes will remain positive throughout the charging process. Because both precious metal plates are now active and releasing atoms and nano-particles, productivity is doubled. Each of your active outer plates is Anode (RED) while liberating atoms which are being continually etched off from the surface of each active Anode plate simultaneously. The central plate is Cathode (BLACK) stainless steel and passively receiving current and accumulating (plating) unwanted oxide debris which can easily be cleaned later from the high quality stainless steel plate. We have noticed that the water becomes blackened and full of large particles of silver oxides. These will fall to the bottom of your container after one day of rest, resulting in a clear colloidal water. Taste the water to verify ppm. Don’t rely on the conductivity meter which measures only ions, not nanoparticles
UPGRADE #2:
High Booster Voltage Our latest generators now have an internal booster module to step 12 volts up to 100 or more volts (up to 1000v). Use our new 12 volt international power supply not the old 48 or 24 volt supplies which will damage and destroy the new 12 volt generator. 12 volts is more convenient to be able to use an automobile battery or solar panel in cases of power failures. Use only a 12 volt power supply, at 3 amps.
UPGRADE #3
Stirring: In place of the old stirrer motor and magnetic stirrer, the steel electrode will be centrally mounted. Stirring can be accomplished using a laboratory-style motorized magnetic plate which induces a magnetic vortex, or using an immersible aquarium water pump for large containers over 1 gallon.
Stirring is important in order to prevent our precious atoms from depositing on to the cathode instead of circulating in the water as a colloidal suspension of charged nanoparticles.
Upgrade: The above 2 upgrades will now be included the immersible pump, steel electrode and 100 volt step-up module to overcome lack of Conductivity of Distilled water + labour. Cost = $380 USD for single channel and $480 for double channel models.
